How to Build a Smok Pen
The Smok Pen is a revolutionary vaporizing pen which allows for a write-to-write experience, whilst you are abroad. This is due to the unique design of the pen. It has two tanks, one smaller compared to the other, that house the e juice and charged batteries. When the user wants to write, he just places the pen in to the smaller tank and places the ink in the chamber where it’ll be vaporized. He simply turns on the pen and writes as if he is writing under a black mirror.
One of the biggest attributes of the Smok Pen is its ability to charge while it is on your own desk. It is because the coils on the Smok Pen are designed in a way to help keep the e juice from dripping onto the table or somewhere else. This is because of the 0.3-ohm coil that is placed in the Smok Pen. The 0.3-ohm coil means that even the slightest of air currents will not affect the writing process. It is because the electronic circuitry has protection built in so that it will not be affected by extremely low voltage electric currents.
The Smok Pen could be charged internally with a charger or via the USB connection that is included with it. Because the electronic circuitry has a safety barrier built in, which means that there is absolutely no risk involved when charging the device through the computer. The Smok Pen has a charging capacity of sixteen 50 mah batteries, that is ideal for all pens that use one or two batteries.
To keep the Smok Pen doing work for an extended period of time it is important that you don’t overcharge the battery. Overcharging the battery will certainly reduce the voltage that’s available and may eventually bring about these devices malfunctioning. Overcharging the Smok Pen may also affect the vaporizing process. If you feel that your battery is not getting the vapor it should, remove the pen from the energy source and let it cool off for a few minutes.
The fire button on the Smok Pen is situated at the bottom right corner of the device. The fire button has an orange light, which indicates that it is on. You can press this button to activate the electronic heating element that will enable you to vaporize the oil. After you have done so you can take away the coil from the holder and stick it into the holder and place the Smok Pen in to the airflow chamber, which will cause the heating element to start heating up and burning away the wick.
When the coil is removed from the holder the airflow chamber is ready for the sub-ohm cartridge. The coils are placed inside the holder and they get heated from the airflow. After they get hot they begin to turn blue, which is the indication that it is ready for the pen’s battery. Ensure that you place your sub-ohm into the chamber before you push the fire button. If you don’t put the coil in to the airflow chamber then your oil will leak and cause the leaking of e-juice.
Before you put the battery in to the pen, you must make sure that you have disconnected all of the leads. Then you need to remove the Smok Pen’s cap and locate the leak or drip tip. You must clean this with a small cotton bud, so that you could get rid of the leak. Then reattach the cap back again to the Smok Pen and you also are prepared to place the battery in to the pen.
The final portion of the construction process is the adapter JUUL Pods plate, which fits in to the Smok Vaporizer’s USB port. This plate lets you charge your e-juice during your computer, as long as you have an adapter for USB connection. I like this part since it allows me to charge my entire kit simultaneously without worrying about running out of power or constantly running out of e-juice.